Quad Display Board - Real-time capture, BME280 sensor, dual-core MCU, Wi-Fi, Bluetooth LE, GPIOs, and more!

Introducing the latest addition to SB Components' product lineup: the Quad Display Board, powered by ESP32 S3 WROOM-1/Raspberry Pi Pico! Get ready for real-time capture, BME280 sensor integration, a dual-core MCU, Wi-Fi, Bluetooth LE, GPIOs, and support for MicroPython, CircuitPython, and Arduino programming. It's innovation at its finest!

Choose between the 1.28" Round Display or the 1.54" Square Display, and dive into a world of possibilities. Whether you opt for the Raspberry Pi Pico Powered Version or the ESP32 S3 WROOM-1 Powered Version, you're guaranteed seamless integration and exceptional performance.

From real-time capture to BME280 sensor integration, dual-core MCU, Wi-Fi, Bluetooth LE, GPIOs, and support for MicroPython, CircuitPython, and Arduino programming, the Quad Display Board has it all. Experience the freedom to create, innovate, and customize to your heart's content.

USB 1.1 support with device and host capabilities, drag-and-drop programming via mass storage over USB, and SPI-based display interfacing ensure smooth communication and effortless development. With RGB appearance, 65K/262K colors, and four programmable buttons, your projects will dazzle and delight.

Monitor environmental conditions with precision using the onboard BME280 sensor, ensure accurate timing with the DS3231 RTC, and log and store project data effortlessly with the integrated MicroSD card. Plus, stay mobile with the battery connector and charging circuit for portable use.

Unlock endless possibilities with support for MicroPython, CircuitPython, and Arduino programming. Whether you're a seasoned developer or a newcomer to the world of coding, the Quad Display Board makes it easy to bring your ideas to life.

Raspberry Pi Pico:

·         Dual-core Arm Cortex-M0+ processor, running up to 133 MHz

·         264kB on-chip SRAM

·         2MB on-board QSPI flash

·         USB 1.1 controller and PHY with host and device support

·         GPIO pins, UART, SPI controllers, I2C controllers, PWM channels

·         Temperature sensor, low-power sleep modes

·         Supported input voltage 1.8–5.5V DC

·         Operating temperature -20°C to +85°C

·         Read more in datasheet

ESP32 S3 WROOM-1:

·         Xtensa® dual-core 32-bit LX7 microprocessor, up to 240 MHz

·         384 KB ROM, 512 KB SRAM, Up to 8 MB PSRAM

·         802.11 b/g/n Wi-Fi, Bluetooth LE: Bluetooth 5, Bluetooth mesh

·         USB 1.1 OTG, SPI, UART, I2C, I2S, ADC, touch sensor, temperature sensor, timers, watchdog, and more.

·         Integrated components including SPI flash, crystal oscillator

·         Read More in datasheet

These displays are available from £45 on Kickstarter, and they have already reached their goal in a few hours. Don't miss out on this opportunity to revolutionize your projects. Join us on Kickstarter and pledge your support today!